Description
Interface Specification, GN-9287 (PROFINET NETWORK ADAPTER) | ||
Adapter Type | Slave node (Profinet) | |
Protocol | Profinet, Modbus RTU | |
Max. Expantsion Module | 32 slots | |
Max. Data Size | Max 1440 bytes | |
Max Length Bus Line | Up to 100m from Ethernet Hub/Switch with twisted CAT5 UTP/STP | |
Max. Nodes | Limited by Profinet Specification. | |
Baud Rate | 100Mbps, Auto-negotiation, Full duplex | |
Interface Connector | RJ-45 socket * 2pcs | |
IP-Address Setup | Via Master Device Software | |
Max. Parameter Size | 2048 Bytes (ex : 1 slot = 64 Byte + I/O Parameter Size(Dword size)) | |
Serial Port | RS232 for MODBUS/RTU, Touch Pannel | |
Serial Configuration (RS232) | Node : 1 (Fixed) Baud Rate : 115200 (Fixed) Data bit : 8 (Fixed) Parity bit : No parity (Fixed) Stop bit : 1 (Fixed) |
|
Indicator | 6 LEDs
1 Green/Red, Module Status (MOD) 1 Green, Physical Connection (NET) 1 Green/Red, Network Error (ERROR) 1 Green/Red, Expansion I/O Module Statsus (IOS) 1 Green, System Power Status 1 Green, Field Power Status 2 LEDs (each RJ45 Connector) 1 Yellow, Link/Active 1 Green, Not used |
|
Module Location | Starter module left side of G-Series system | |
Field Power Detection | About 14Vdc | |
General Specification | ||
UL System Power | Supply voltage : 24Vdc nominal, Class2 | |
System Power | Supply voltage : 24Vdc nominal Supply voltage range : 15~30Vdc Protection : Output current limit (Min. 1.5A) Reverse polarity protection |
|
Power Dissipation | 70mA typical @ 24Vdc | |
Current for I/O Module | 1.5A @ 5Vdc | |
Isolation | System power to internal logic : Non-isolation System power I/O driver : Isolation |
|
UL Field Power | Supply voltage : 24Vdc nominal, Class2 | |
Field Power | Supply voltage : 24Vdc typical (Max. 30Vdc) * Field Power Range is different depending on IO Module series. Refer to IO Module`s Specification. |
|
Max. Current Field Power Contact | DC 10A Max. | |
Weight | 172g | |
Module Size | 54mm x 99mm x 70mm |