Description
| Interface Specification, GN-9587 (PROFINET NETWORK ADAPTER) | |
| Adapter Type | Slave node (Profinet) |
| Protocol | Profinet, Modbus RTU |
| Max. Expantsion Module | 32 slots |
| Max. Data Size | Max 1440 bytes |
| Max Length Bus Line | Up to 100m from Ethernet Hub/Switch with twisted CAT5 UTP/STP |
| Max. Nodes | Limited by Profinet Specification. |
| Baud Rate | 100Mbps, Auto-negotiation, Full duplex |
| Interface Connector | RJ-45 socket * 2pcs |
| IP-Address Setup | Via Master Device Software |
| Max. Parameter Size | 2048 Bytes (ex : 1 slot = 64 Byte + I/O Parameter Size(Dword size)) |
| Serial Port | RS232 for MODBUS/RTU, Touch Pannel |
| Serial Configuration (RS232) | Node : 1 (Fixed) Baud Rate : 115200 (Fixed) Data bit : 8 (Fixed) Parity bit : No parity (Fixed) Stop bit : 1 (Fixed) |
| Indicator | 6 LEDs 1 Green/Red, Module Status (MOD) 1 Green, Physical Connection (NET) 1 Green/Red, Network Error (ERROR) 1 Green/Red, Expansion I/O Module Statsus (IOS) 1 Green, System Power Status 1 Green, Field Power Status 2 LEDs (each RJ45 Connector) 1 Yellow, Link/Active 1 Green, Not used |
| Module Location | Starter module left side of G-Series system |
| Field Power Detection | About 14Vdc |
| General Specification | |
| UL System Power | Supply voltage : 24Vdc nominal, Class2 |
| System Power | Supply voltage : 24Vdc nominal Supply voltage range : 15~30Vdc Protection : Output current limit (Min. 1.5A) Reverse polarity protection |
| Power Dissipation | 70mA typical @ 24Vdc |
| Current for I/O Module | 1.5A @ 5Vdc |
| Isolation | System power to internal logic : Non-isolation System power I/O driver : Isolation |
| UL Field Power | Supply voltage : 24Vdc nominal, Class2 |
| Field Power | Supply voltage : 24Vdc typical (Max. 30Vdc) * Field Power Range is different depending on IO Module series. Refer to IO Module`s Specification. |
| Max. Current Field Power Contact | DC 10A Max. |
| Weight | 172g |
| Module Size | 54mm x 99mm x 70mm |
