Description
| Interface Specification, GN-9386 (EtherCAT ID Type Network Adapter) | ||
| Adapter Type | Slave Node (EtherCAT) | |
| Max. Expansion Slot | 63 slots | |
| I/O Data Size | Max 128 bytes each slot | |
| Max. Network Node | 65,535 | |
| Baud Rate | 100Mbps | |
| Bus Connection | 2 x RJ-45 | |
| Mac Address / IP Address | Not needed | |
| Other Serial Port | RS232 for MODBUS/RTU, Touch Panel or IOGuide(Crevis Software) | |
| Serial Configuration (RS232) | Node : 1 (Fixed) Baud Rate : 115200 (Fixed) Data bit : 8 (Fixed) Parity bit : No parity (Fixed) Stop bit : 1 (Fixed) | |
| Indicator | 6 Status LEDs 1 Green/Red, Module Status (MOD) 1 Green, Network Status (RUN) 1 Red, Error Status (ERROR) 1 Green/Red Expansion I/O Module Statsus (IOS) 1 Green, System Power Status 1 Green, Field Power Status | |
| Module Location | Starter module left side of G-Series system | |
| Field Power Detection | About 14Vdc | |
| General Specification | ||
| UL System Power | Supply voltage : 24Vdc nominal, Class2 | |
| System Power | Supply voltage : 24Vdc nominal Supply voltage range : 15~30Vdc Protection : Output current limit (Min. 1.5A) Reverse polarity protection | |
| Power Dissipation | 70mA @ 24Vdc | |
| Current for I/O Module | 1.5A @ 5Vdc | |
| Isolation | System power to internal logic : Non-isolation System power I/O driver : Isolation | |
| UL System Power | Supply voltage : 24Vdc nominal, Class2 | |
| Field Power | Supply voltage : 24Vdc typical (Max. 30Vdc) * Field Power Range is different depending on IO Module series. Refer to IO Module`s Specification. | |
| Weight | 167g | |
| Module Size | 54mm x 99mm x 70mm | |
