Description
| Interface Specification, GN-9251 (BACnet/IP Network Adapter) | ||
| Adapter Type | Slave node (BACnet/IP) | |
| BACnet Device Profile | BACnet Application Specific Controller (B-ASC) | |
| Max. Supported Object Size | 256 objects  (IO channels only)* | |
| BACnet Protocol Version | 1 | |
| BACnet Protocol Revision | 12 | |
| Max. Expantsion Module | 32 slots | |
| Sub Protocol | MODBUS/TCP,MODBUS/UDP,HTTP,DHCP,10 TCP Connections | |
| Max Length Bus Line | Up to 100m from Ethernet Hub/Switch with twisted CAT5 UTP/STP | |
| Max. Nodes | Limited by Ethernet Specification. | |
| Baud Rate | 10/100Mbps, Auto-negotiation, Full duplex | |
| Interface Connector | RJ-45 socket * 2pcs | |
| IP-Address Setup | Via DHCP/BOOTP or IOGuide(Crevis Software) | |
| IP-Address Range | xxx.xxx.xxx.1 ~ 253 | |
| IAP Mode | Set dip sw to 254. – IAP web-server IP: 192.168.0.100 – Using only Internet Explorer / recommended version 11 | |
| Serial Port | RS232 for MODBUS/RTU, Touch Pannel or IOGuide | |
| Serial Configuration (RS232) | 1 Node, 115200 baud, 8 data bits, no parity, 1 stop bit (Fixed) | |
| Indicator *Refer to ‘2.3. LED Indicator’ | 6 LEDs – Window Lable MOD, LINK, ACTIVE, IOS, System Power, Field Power 2 LEDs – each RJ45 Connector Yellow(Link/Active), Green(Not used) | |
| Module Location | About 14Vdc | |
| General Specification | ||
| UL System Power | Supply voltage : 24Vdc nominal, Class2 | |
| System Power | Supply voltage : 24Vdc nominal Supply voltage range : 15~30Vdc Protection : Output current limit (Min. 1.5A) – Reverse polarity protection | |
| Power Dissipation | 70mA typical @ 24Vdc | |
| Current for I/O Module | 1.5A @ 5Vdc** | |
| UL Field Power | Supply voltage : 24Vdc nominal, Class2 | |
| Isolation | System power to internal logic : Non-isolation System power I/O driver : Isolation | |
| Field Power | Supply voltage : 24Vdc typical (Max. 30Vdc) *** | |
| Max. Current Field Power Contact | DC 10A Max | |
| Weight | 162g | |
| Module Size | 54mm x 99mm x 70mm | |
